Sock, Polyester Blend
Everyone wants printed socks. Almost nobody is told what happens to the pattern when a foot goes in.
€13.00
Per piece, VAT included, before printing. Printing is added in the studio and the quantity tier is applied to the combined figure.
Optic white
Light substrate — the full tonal range is available.
Important — Read before ordering
4% elastane and a knitted shape. The artwork is printed on the sock lying flat and then stretches over the foot and ankle, so the pattern distorts as it is worn. Heel and toe distort the most.
Important — Read before ordering
22% non-polyester fibre. Colour lands slightly softer than on a 100% polyester blank.
How it takes the dye
- Polyester content
- 78% — the remaining 22% takes no disperse dye, so colour lands roughly 20% lighter than the same file on a 100% polyester blank.
- Fibre composition
- 78% polyester, 18% polyamide, 4% elastane
- Printable area
- The whole sock, printed before it is worn.
- Seam whitening
Medium. Some multi-layer construction. Colour thins visibly along the zones listed below, and artwork crossing them will show a break.
Zones — Toe seam · Heel turn · Cuff rib
- Sizes
- 35–38 · 39–42 · 43–46
Print specifications
Specs this blank cannot physically take are disabled here and in the studio, with the reason written out rather than hidden.
- All-over+€12.00 · min 1
The whole piece, front, back, sleeves and side seams.
- Front panelNot available
Not offered on this blank. 4% elastane and a knitted shape. The artwork is printed on the sock lying flat and then stretches over the foot and ankle, so the pattern distorts as it is worn. Heel and toe distort the most.
- Front + backNot available
Not offered on this blank. 4% elastane and a knitted shape. The artwork is printed on the sock lying flat and then stretches over the foot and ankle, so the pattern distorts as it is worn. Heel and toe distort the most.
- Panel-cutNot available
Not offered on this blank. 4% elastane and a knitted shape. The artwork is printed on the sock lying flat and then stretches over the foot and ankle, so the pattern distorts as it is worn. Heel and toe distort the most.
Labelling and end of life
- Fibre composition
- 78% polyester, 18% polyamide, 4% elastane — labelled in accordance with Regulation (EU) No 1007/2011.
- Care
- Machine wash at 30 °C inside out. Do not bleach. Do not tumble dry. Iron on the reverse only at low heat (110 °C) — never directly on the printed face. Do not dry clean.
- Care after printing
- Wash inside out at 30 °C. Iron only on the reverse at low heat — never place an iron directly on the printed face, which can glaze the fibre. Do not tumble dry.
- Origin
- The country of manufacture is printed on the sewn-in label of the blank you receive. It varies by production batch, so we do not state a single country here.
- Sorting and recycling
- Carries the Triman sorting mark and falls under the French TLC extended-producer-responsibility scheme operated by Refashion (filière TLC — textiles, linge de maison, chaussures). Sorting instructions and our EPR identifier.
Configure it and the studio will measure your artwork against this blank in particular.
Fibre content, base colour and seam zones all feed the gamut figure, so the number you see is specific to the piece you have chosen — not a generic estimate.
Questions before you order: +33 7 63 04 90 75 · support@trendsseason.site
